RhizoSystems, LLC

Down to earth sensing.






Creators of the world's first fully automated and remotely programable minirhizotron.


Your Subtitle text

Specifications for the Automated Mini-Rhizotron


Preliminary specifications for the AMR-B. This information is based on the AMR-A units. Several engineering changes have been made since the AMR-A was built. It is anticipated that the AMR-B will meet or improve upon these values.  All specifications are subject to change.

Imager: 1/3.2 inch (4:3), 2Mp color sensor. 1,920,000 effective pixels

Units: Pixels

Range: 320x240, 640x480 [1280x1040, 1600x1200]

Precision: 10um

Accuracy: 10um

Sample Rate: programmable -- typically 2.75 seconds per image captured

Camera: Digital Imagery Measurement List Non-Critical Requirements

Image size: 3.01mm (width) x 2.26mm (height) (at 100x)

Maximum imaging area: 320mm x 740mm (optional 1M)

Typical imaging depth: 130mm to 730mm (installed at 40° angle)

Maximum number of images per tube: 32,928 (41,197 optional w/1M option)

Magnification: 100X [50X also available]

Wavelength of light source: 322nm

Physical:

Length (including handle and anti-spin tail fin): 156.87cm

Diameter: 107.95mm (Handle width 119.38mm)

Weight: Approximately 8.2kg

Environmental:

Operating range: -20C to +50C ambient air temp. The AMR uses the ground as a

heat sink. Use in ground temps exceeding 40C (at 20cm) is not recommended

and may damage the unit. Use in moist ground frozen deeper than 200mm may

cause damage and cause less than repeatable results due to frost heave.

Humidity: Unit is submersible to 200mm (using optional connector and wiring harness).  Ancillary equipment is not.

Performance:

MTBF (mechanical): Greater than 8,000 hours (prototype unit, 24/7 operation)

Power:

Maximum: 110W (w/optional ancillary housing heater running)

Nominal: < 50W

Hardware/SW Required:

Each AMR includes an ancillary housing containing: a small computer

running Windows, a UPS, thermostatically controlled fans with shrouds, a network switch, a 12VDC power
supply and bus, moisture management system (pump, tubing, replaceable desiccant filter, control module) for AMR,
and a network controllable outlet switch for remote management.
The user interface (RootView™) is web-based and compatible with most browsers. RhizoSystems includes a preconfigured

system with each AMR.
End user is responsible for providing Network (wired or wireless (802.11g/n)) and 115VAC, 60Hz, 2A to each ancillary housing.

Calibration Procedures:

The AMR unit typically does not require routine calibration. If the user begins to

notice over/under lap of mosaic images or if errors greater than 500 microns are

reported on sequential homing operations, the unit would need to be returned to

the RhizoSystems for repair. (RootView3n includes a programmable alert

function that notifies the user of this condition (and many others).)

Historical data:

The AMR Prototype unit has been in use doing science since 31 July 2008 while

at the same time, being routinely reworked and modified due to it being a

prototype. Images captured since first light have been published and have

resulted in fundamental new discoveries by observing the previously

unobservable.

Packaging:

Each AMR unit is shipped in a well-packaged, durable, reusable, container that

can also be used for storage. FedEx or UPS overnight service is recommended

for shipping along with an appropriate amount of insurance.

Training: $1,000 per day plus expenses (on-site only).

Sustainability statement:

The AMR was developed by funding provided by the NSF to the Center for

Embedded Networked Sensing and to the Center for Conservation Biology.

RhizoSystems, LLC, was formed in January 2010 to commercialize the product

and work in partnership with the University of California to advance soil

ecosystem research. While a startup, both the company and its advisory board

bring decades of science research, start-up experience and business acumen to

bear on this goal. We have many innovative ideas and a team of people

dedicated to bringing them to life. A list of participants is available upon

request.

Website Builder